#!/bin/sh set -e # Automatically added by dh_python3 if which py3compile >/dev/null 2>&1; then py3compile -p supervisor fi if which pypy3compile >/dev/null 2>&1; then pypy3compile -p supervisor || true fi # End automatically added section # Automatically added by dh_installinit/13.3.4 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if [ -x "/etc/init.d/supervisor" ]; then update-rc.d supervisor defaults >/dev/null if [ -n "$2" ]; then _dh_action=restart else _dh_action=start fi invoke-rc.d --skip-systemd-native supervisor $_dh_action || exit 1 fi fi # End automatically added section # Automatically added by dh_installsystemd/13.3.4 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then # This will only remove masks created by d-s-h on package removal. deb-systemd-helper unmask 'supervisor.service' >/dev/null || true # was-enabled defaults to true, so new installations run enable. if deb-systemd-helper --quiet was-enabled 'supervisor.service'; then # Enables the unit on first installation, creates new # symlinks on upgrades if the unit file has changed. deb-systemd-helper enable 'supervisor.service' >/dev/null || true else # Update the statefile to add new symlinks (if any), which need to be # cleaned up on purge. Also remove old symlinks. deb-systemd-helper update-state 'supervisor.service' >/dev/null || true fi fi # End automatically added section # Automatically added by dh_installsystemd/13.3.4 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if [ -d /run/systemd/system ]; then systemctl --system daemon-reload >/dev/null || true if [ -n "$2" ]; then _dh_action=restart else _dh_action=start fi deb-systemd-invoke $_dh_action 'supervisor.service' >/dev/null || true fi fi # End automatically added section